Category Archives:
Essay Writing Help

With reference to Fig. 5-10, (a) Derive an expression for With reference to Fig. 5-10, (a) Derive an expression for the vector magnetic potential A at a point P located at a distance r from the wire in the x–y plane, and then (b) Derive B from A. Show that your result is identical with […]

With reference to Fig. 4-19, find E1 if E2 = x3 – y2 + z2 (V/m) With reference to Fig. 4-19, find E1 if E2 = x3 – y2 + z2 (V/m), 1 = 20, 2 = 180, and the boundary has a surface charge density s = 3.54 x10-11 (C/m2). What angle does E2 […]

The rectangular conducting loop shown in Fig. 6-20 (P6.7) The rectangular conducting loop shown in Fig. 6-20 (P6.7) rotates at 6,000 revolutions per minute in a uniform magnetic flux density given by B = y50 (mT) Determine the current induced in the loop if its inte rnal resistance is 0 5 . Is this the […]

(a) Contrast the manner in which stress relaxation and viscoelas (a) Contrast the manner in which stress relaxation and viscoelastic creep tests are conducted. (b) For each of these tests, cite the experimental parameter of interest and how it is determined. Is this the question you were looking for? If so, place your order here […]

Fundamentals of economics Fundamentals of Economics Assignment # 1 1. Provide an example of each of the factors of production and how the government may alter the factor to expand the productive ability of the economy? Provide a chart if needed? 2. Explain the concept of comparative advantage. How does this concept explain that it […]

(a) Derive linear density expressions for BCC [110] and [111] (a) Derive linear density expressions for BCC [110] and [111] directions in terms of the atomic radius R. (b) Compute and compare linear density values for these same two directions for tungsten. Is this the question you were looking for? If so, place your order […]

(a) Derive linear density expressions for (a) Derive linear density expressions for FCC [100] and [111] directions in terms of the atomic radius R. (b) Compute and compare linear density values for these same two directions for silver. Is this the question you were looking for? If so, place your order here to get started!

a) Compute the voltage at 25°C of an electrochemical cell (a) Compute the voltage at 25째C of an electrochemical cell consisting of pure cadmium immersed in a 2 ( 10-3 M solution of Cd2+ ions, and pure iron in a 0.4 M solution of Fe2+ ions. (b) Write the spontaneous electrochemical reaction. Is this the […]

A polystyrene component must not fail when a tensile stress A polystyrene component must not fail when a tensile stress of 1.25MPa (180psi) is applied. Determine the maximum allowable surface crack length if the surface energy of polystyrene is 0.50 J/m2 (2.86 ( 10-3 in.-lbf/in.2). Assume a modulus of elasticity of 3.0GPa (0.435 ( 106psi). […]

A piece of corroded steel plate was found in a A piece of corroded steel plate was found in a submerged ocean vessel. It was estimated that the original area of the plate was 10 in.2 and that approximately 2.6 kg had corroded away during the submersion. Assuming a corrosion penetration rate of 200 mpy […]