Category Archives:
Essay Writing Help

A parallel-plate capacitor with dimensions of 100 mm by 25 A parallel-plate capacitor with dimensions of 100 mm by 25 mm and a plate separation of 3 mm must have a minimum capacitance of 38 pF (3.8 ( 10-11 F) when an ac potential of 500 V is applied at a frequency of 1 MHz. […]

Calculate the fraction of lattice sites that are Schottky defect Calculate the fraction of lattice sites that are Schottky defects for sodium chloride at its melting temperature (801째C). Assume an energy for defect formation of 2.3 eV. Is this the question you were looking for? If so, place your order here to get started!

A parallel-plate capacitor using a dielectric material having A parallel-plate capacitor using a dielectric material having an r of 2.5 has a plate spacing of 1 mm (0.04 in.). If another material having a dielectric constant of 4.0 is used and the capacitance is to be unchanged, what must be the new spacing between the […]

A load of 85,000 N (19,100lbf) is applied to a A load of 85,000 N (19,100lbf) is applied to a cylindrical specimen of a steel alloy (displaying the stress–strain behavior shown in Figure) that has a cross-sectional diameter of 15 mm (0.59 in.). (a) Will the specimen experience elastic and/or plastic deformation? Why? (b) If […]

A large-particle composite consisting of tungsten particles with A large-particle composite consisting of tungsten particles within a copper matrix is to be prepared. If the volume fractions of tungsten and copper are 0.60 and 0.40, respectively, estimate the upper limit for the specific stiffness of this composite given the data thatfollo Is this the question […]

Calculate the number of vacancies per cubic meter in iron Calculate the number of vacancies per cubic meter in iron at 850(C. The energy for vacancy formation is 1.08 eV/atom. Furthermore, the density and atomic weight for Fe are 7.65 g/cm3 and 55.85 g/mol, respectively. Is this the question you were looking for? If so, […]

A large tower is to be supported by a series A large tower is to be supported by a series of steel wires. It is estimated that the load on each wire will be 11,100 N (2500lbf). Determine the minimum required wire diameter assuming a factor of safety of 2 and a yield strength of […]

A sheet of BCC iron 1 mm thick was exposed A sheet of BCC iron 1 mm thick was exposed to a carburizing gas atmosphere on one side and a decarburizing atmosphere on the other side at 725(C. After having reached steady state, the iron was quickly cooled to room temperature. The carbon concentrations at […]

A specimen of ductile cast iron having a rectangular cross A specimen of ductile cast iron having a rectangular cross section of dimensions 4.8 mm ( 15.9 mm (3/16 in. ( 5/8 in.) is deformed in tension. Using the load-elongation data tabulated below, complete problems (a) through (f). (a) Plot the data as engineering stress […]

A specimen of aluminum having a rectangular cross section 10 A specimen of aluminum having a rectangular cross section 10 mm ( 12.7 mm (0.4 in. ( 0.5 in.) is pulled in tension with 35,500 N (8000 lbf) force, producing only elastic deformation. Calculate the resulting strain. Is this the question you were looking for? […]