In order to test the properties of a sample of

In order to test the properties of a sample of

In order to test the properties of a sample of electrical steel, a set of laminations of the form of figure have been stamped out of a sheet of the electrical steel of thickness 3.0 mm. The radii of the laminations are Ri = 75 mm and Ro = 82 mm. They have been assembled in a stack of 10 laminations (separated by appropriate insulation to eliminate eddy currents) for the purposes of testing the magnetic properties at a frequency of 100 Hz.
a. The flux in the lamination stack will be excited from a variable-amplitude, 100-Hz voltage source whose peak amplitude is 30 V (peak-to-peak). Calculate the number of turns N1 for the excitation winding required to insure that the lamination stack can be excited up to a peak flux density of 2.0T.
b. With a secondary winding of N2 = 20 turns and an integrator gain G = 1000, the output of the integrator is observed to be 7.0 V peak-to-peak. Calculate (i) the corresponding peak flux in the lamination stack and (ii) the corresponding amplitude of the voltage applied to the excitationwinding.

Is this the question you were looking for? If so, place your order here to get started!