mechanical engineering hydaulics

mechanical engineering hydaulics

When answering this question, please don’t focus on showing the
ladle, just show that the ram has to overcome a negative force of
4,800 newton. On your assignment, show in a table format, the
properties of the variousA ladle as shown in the figure below is used to pass liquid
aluminum from a holding furnace into a channel leading to a
die-casting machine. This movement of the ladle is enabled by a
double-acting cylinder activated by a 4/2-way valve. It must be
mentioned that the ladle should not be allowed to dip into the
furnace when the valve is in an unactuated condition.a) Design a circuit diagram to illustrate the working of the
ladle. Allow for the fact that the ladle represents a large
load.b) Choose the cylinder diameter, given the following data:• Maximum system pressure p = 38 bar • Required lifting force F
= 4800 N.The system resistances may be ignored{{

Is this the question you were looking for? If so, place your order here to get started!