Category Archives:
Essay Writing Help

A source emits one of four symbols s0, s1, s2, A source emits one of four symbols s0, s1, s2, and s3 with probabilities 1/3, 1/6, 1/4, and 1/4, respectively. The successive symbols emitted by the source are statistically independent. Calculate the entropy ol the source. Is this the question you were looking for? If […]

The activation energy for the diffusion of carbon in chromium The activation energy for the diffusion of carbon in chromium is 111,000 J/mol. Calculate the diffusion coefficient at 1100 K (827(C), given that D at 1400 K (1127(C) is 6.25 ( 10-11 m2/s. Is this the question you were looking for? If so, place your […]

Ten kilogram of polybutadiene is vulcanized with 4.8 kg sulfur. Ten kilogram of polybutadiene is vulcanized with 4.8 kg sulfur. What fraction of the possible crosslink sites is bonded to sulfur crosslinks, assuming that, on the average, 4.5 sulfur atoms participate in each crosslink? Is this the question you were looking for? If so, place […]

Taking the logarithm of both sides of Equation 6.19 yields Thus, a plot of log sT versus log ?T in the plastic region to the point of necking should yield a straight line having a slope of n and an intercept (at log sT = 0) of log K. Using the appropriate data tabulated in […]

Suppose that the fatigue data for the cast iron in Suppose that the fatigue data for the cast iron in Problem 8.20 were taken for bending-rotating tests, and that a rod of this alloy is to be used for an automobile axle that rotates at an average rotational velocity of 750 revolutions per minute. Give […]

Specify an acceptor impurity type and concentration Specify an acceptor impurity type and concentration (in weight percent) that will produce a p-type silicon material having a room temperature electrical conductivity of 50 (ohm-m)-1. Is this the question you were looking for? If so, place your order here to get started!

Suppose that the fatigue data for the brass alloy in Suppose that the fatigue data for the brass alloy in Problem 8.18 were taken from torsional tests, and that a shaft of this alloy is to be used for a coupling that is attached to an electric motor operating at 1500 rpm. Give the maximum […]

Suppose that a wing component on an aircraft is fabricated Suppose that a wing component on an aircraft is fabricated from an aluminum alloy that has a plane strain fracture toughness of 40MPavm (36.4ksivin). It has been determined that fracture results at a stress of 365MPa (53,000psi) when the maximum internal crack length is 2.5 […]

For each of the following pairs of semiconductors, decide which For each of the following pairs of semiconductors, decide which will have the smaller band gap energy, Eg, and then cite the reason for your choice. (a) ZnS and CdSe, (b) Si and C (diamond), (c) Al2O3 and ZnTe, (d) InSb and ZnSe, and (e) […]

Sometimes cos ( cos ( in Equation 7.2 is termed Sometimes cos ( cos ( in Equation 7.2 is termed the Schmid factor. Determine the magnitude of the Schmid factor for an FCC single crystal oriented with its [100] direction parallel to the loadingaxis. Is this the question you were looking for? If so, place […]