Name the following polymer(s) that would be suitable for the Name the following polymer(s) that would be suitable for the fabrication of cups to contain hot coffee: polyethylene, polypropylene, poly (vinyl chloride), PET polyester, and polycarbonate. Why? Is this the question you were looking for? If so, place your order here to get started!
Read More »Molybdenum forms a substitutional solid solution with tungsten Molybdenum forms a substitutional solid solution with tungsten. Compute the weight percent of molybdenum that must be added to tungsten to yield an alloy that contains 1.0 ( 1022 Mo atoms per cubic centimeter. The densities of pure Mo and W are 10.22 and 19.30 g/cm3, respectively. […]
Read More »Is it possible to produce an iron-carbon alloy of eutectoid Is it possible to produce an iron-carbon alloy of eutectoid composition that has a minimum hardness of 90 HRB and a minimum ductility of 35%RA? If so, describe the continuous cooling heat treatment to which the alloy would be subjected to achieve these properties. If […]
Read More »It is desired to enrich the partial pressure of hydrogen It is desired to enrich the partial pressure of hydrogen in a hydrogen-nitrogen gas mixture for which the partial pressures of both gases are 0.1013MPa (1atm). It has been proposed to accomplish this by passing both gases through a thin sheet of some metal at […]
Read More »It is desired that the reflectivity of light at normal It is desired that the reflectivity of light at normal incidence to the surface of a transparent medium be less than 6.0%. Which of the following materials in Table 21.1 are likely candidates: silica glass, Pyrex glass, corundum, spinel, polystyrene, and polytetrafluoroethylene? Justify yourselection(s). Is […]
Read More »Is it possible to temper an oil-quenched 4140 steel cylindrical Is it possible to temper an oil-quenched 4140 steel cylindrical shaft 100 mm (4 in.) in diameter so as to give a minimum tensile strength of 850 MPa (125,000 psi) and a minimum ductility of 21%EL? If so, specify a tempering temperature. If this is […]
Read More »Is it possible to produce malleable cast iron in pieces Is it possible to produce malleable cast iron in pieces having large cross-sectional dimensions? Why or why not? Is this the question you were looking for? If so, place your order here to get started!
Read More »Is it possible to produce an oil-quenched and tempered 4340 Is it possible to produce an oil-quenched and tempered 4340 steel that has a minimum yield strength of 1400MPa (203,000psi) and a ductility of at least 42%RA? If this is possible, describe the tempering heat treatment. If it is not possible, explain why. Is this […]
Read More »Is it possible to produce an iron-carbon alloy that has Is it possible to produce an iron-carbon alloy that has a minimum tensile strength of 690MPa (100,000psi) and a minimum ductility of 40%RA? If so, what will be its composition and microstructure (coarse and fine pearlites and spheroidite are alternatives)? If this is not possible, […]
Read More »Is it possible to have an iron-carbon alloy for which the mass Is it possible to have an iron-carbon alloy for which the mass fractions of total ferrite and proeutectoid cementite are 0.846 and 0.049, respectively? Why or why not? Is this the question you were looking for? If so, place your order here to […]
Read More »
WebMail