Category Archives:
Essay Writing Help

At approximately what temperature would a specimen of g-iron hav At approximately what temperature would a specimen of g-iron have to be carburized for 2 h to produce the same diffusion result as at 900(C for 15 h? Is this the question you were looking for? If so, place your order here to get started!

A steel bar 100 mm (4.0 in.) long and having A steel bar 100 mm (4.0 in.) long and having a square cross section 20 mm (0.8 in.) on an edge is pulled in tension with a load of 89,000 N (20,000 lbf), and experiences an elongation of 0.10 mm (4.0 ( 10-3 in.). Assuming […]

Calculate the moduli of resilience for the materials having the Calculate the moduli of resilience for the materials having the stress–strain behaviors shown in Figures 6.12 and6.21. Is this the question you were looking for? If so, place your order here to get started!

A steel alloy specimen having a rectangular cross section A steel alloy specimen having a rectangular cross section of dimensions 12.7 mm A? 6.4 mm (0.5 in. A? 0.25 in.) has the stress–strain behavior shown in figure. If this specimen is subjected to a tensile force of 38,000 N (8540lbf) then (a) Determine the elastic […]

At room temperature the electrical conductivity and the electron At room temperature the electrical conductivity and the electron mobility for copper are 6.0 X 107 (-m)-1 and 0.0030 m2/V-s, respectively. (a) Compute the number of free electrons per cubic meter for copper at room temperature. (b) What is the number of free electrons per copper […]

Argon diffuses through a high density polyethylene (HDPE) sheet Argon diffuses through a high density polyethylene (HDPE) sheet 40 mm thick at a rate of 4.0 A? 10–7 (cm3 STP)/cm2-s at 325 K. The pressures of argon at the two faces are 5000 kPa and 1500 kPa, which are maintained constant. Assuming conditions of steady […]

Assume there exists some hypothetical metal that exhibits ferrom Assume there exists some hypothetical metal that exhibits ferromagnetic behavior and that has (1) a simple cubic crystal structure (Figure), (2) an atomic radius of 0.153 nm, and (3) a saturation flux density of 0.76 tesla. Determine the number of Bohr magnetons per atom for thismaterial. […]

Compute (a) The saturation magnetization and (b) The saturatio Compute (a) The saturation magnetization and (b) The saturation flux density for cobalt, which has a net magnetic moment per atom of 1.72 Bohr magnetons and a density of 8.90 g/cm3. Is this the question you were looking for? If so, place your order here to […]

As noted in Section 3.15, for single crystals of some substances As noted in Section 3.15, for single crystals of some substances, the physical properties are anisotropic; that is, they are dependent on crystallographic direction. One such property is the modulus of elasticity. For cubic single crystals, the modulus of elasticity in a general [uvw] […]

An iron bar magnet having a coercivity of 4000 A/m An iron bar magnet having a coercivity of 4000 A/m is to be demagnetized. If the bar is inserted within a cylindrical wire coil 0.15 m long and having 100 turns, what electric current is required to generate the necessary magnetic field? Is this the […]