Category Archives:
Essay Writing Help

Composite materials are now being utilized extensively in sports Composite materials are now being utilized extensively in sports equipment. (a) List at least four different sports implements that are made of, or contain composites. Is this the question you were looking for? If so, place your order here to get started!

Compare white and nodular cast irons with respect to (a) Compare white and nodular cast irons with respect to (a) Composition and heat treatment, (b) Microstructure, and (c) Mechanical characteristics. Is this the question you were looking for? If so, place your order here to get started!

Compare precipitation hardening (Section 11.9) and the hardening Compare precipitation hardening (Section 11.9) and the hardening of steel by quenching and tempering (Sections 10.5, 10.6, and 10.8) with regard to (a) The total heat treatment procedure (b) The microstructures that develop (c) How the mechanical properties change during the several heat treatment stages Is this […]

Calculate the unit cell edge length for an 85 wt% Calculate the unit cell edge length for an 85 wt% Fe-15 wt% V alloy. All of the vanadium is in solid solution, and, at room temperature the crystal structure for this alloy is BCC Is this the question you were looking for? If so, place […]

Assume that the commercial iron (99.95 wt% Fe) in Table Assume that the commercial iron (99.95 wt% Fe) in Table 20.5 just reaches the point of saturation when inserted within the coil in Problem 20.1. Compute the saturationmagnetization. Is this the question you were looking for? If so, place your order here to get started!

According to Table 17.3, the oxide coating that forms on According to Table 17.3, the oxide coating that forms on silver should be nonprotective, and yet Ag does not oxidize appreciably at room temperature and in air. How do you explain this apparentdiscrepancy? Is this the question you were looking for? If so, place your […]

A tubular shaft similar to that shown in Figure 16.11 is A tubular shaft similar to that shown in Figure 16.11 is to be designed that has an outside diameter of 80 mm (3.15 in) and a length of 0.75 m (2.46 ft), the mechanical characteristic of prime importance is bending stiffness in terms of […]

Assume that the composite described in Problem 16.8 has a Assume that the composite described in Problem 16.8 has a cross-sectional area of 320 mm2 (0.50 in.2) and is subjected to a longitudinal load of 44,500 N (10,000lbf). (a) Calculate the fiber–matrix load ratio. (b) Calculate the actual loads carried by both fiber and matrix […]

A thick steel sheet of area 400 cm2 is exposed A thick steel sheet of area 400 cm2 is exposed to air near the ocean. After a one-year period it was found to experience a weight loss of 375 g due to corrosion. To what rate of corrosion, in both mpy and mm/yr, does this […]

A structural member 100 mm (4 in.) long must be A structural member 100 mm (4 in.) long must be able to support a load of 50,000 N (11,250 lbf) without experiencing any plastic deformation. Given the following data for brass, steel, aluminum, and titanium, rank them from least to greatest weight in accordance with […]