Engineering Help

Engineering Help

The SCR in Figure 1 below requires a 3 V trigger. Using Multsim,
design a system by which the gears are shifted when a CdS photocell
resistance drops below 4k.Using Multisim, design a system by which a control signal of 4
to 20 mA is converted into a force of 200 to 1000N. Use a pneumatic
actuator and specify the required diaphragm area if the pressure
output is to be in the range of 20 to 100kPa. An I/P converter is
available that converts 0 to 5 V into 20 to 100 kPa. A block
diagraph of the system is shown below. (Hint: Use a differential
amplifier. You are only designing the circuit to interface into the
I/P below) (Figure 2)

Is this the question you were looking for? If so, place your order here to get started!